Products / Host Cards / PCIe x8 / USB 3.2 Gen 1 (USB 3.0)

U3X8-PCIE8XE111

Octad Channel 32-port (4-port x 8) USB 3.0 to PCI Express x8 Gen 2 Host Card

Specifications

Downloads

Highlights

Host Bus: PCIe x8 Gen 2 (40.0 Gb/s)
- Compliant with PCI Express Base Specification Revision 2.0
Eight independent USB 3.0 Host Controllers
- Compliant with Universal Serial Bus 3.0 specification Revision 1.0
- Compliant with Intel’s eXtensible Host Controller Interface (xHCI) specification Revision 1.0
- USB 3.0 Host Controller supports four downstream ports
thirty-two USB 3.0 Cable Ports (A-type Receptacle)
- Provides USB 3.0 cable port lock mechanism
  
  USB 3.0 Standard A-type lock mechanism
Dual 5.25" ODD Form Factor (DU3X2-IPCIE2XG211 )

Introduction

The U3X8-PCIE8XE111 is an Octad channel 32-port (4-port x 8) USB 3.0 to PCI Express x8 Gen 2 Host Card.

U3X8-PCIE8XE111 is integrated by the following three key parts (IP8X-PCIE8XG201,DU3X2-IPCIE2XG211, CB-00592).

IP8X-PCIE8XG201
- Internal eight PCIe x1 to PCIe x8 Gen 2 Switch Host Card.
Two DU3X2-IPCIE2XG211
- Four PCI Express x1 to USB 3.0 Single Chip Host Controllers ( FRESCO FL1100; USB IF TID 380000026).
Four CB-00592

Utilizing the standard PCI Express Switch, the 16-Lane/16-Port PCI Express Switch provides the most efficient fan-out solution for integrating Sixteen PCI Express to USB 3.0 Single Chip Host controllers into a small board design. Each USB 3.0 to PCI Express Single Chip Host controller takes advantages of 5 Gbps burst rate of 8-lane PCI Express bus in both directions and is fully compliant with PCI Express Base specification r2.0. This solution provides full PCI Express and USB 3.0 functionality and performance.

Technical Specifications

IP8X-PCIE8XG201

Upstream PCIe interface	8-lane PCI Express Throughput PCIe Gen 1: 20 Gbps PCIe Gen 2: 40 Gbps
Downstream PCIe interface	Four IOI Proprietary Dual-lane Internal PCIe Ports (PCIe-1~4) 10X2_19pin Header (Pitch=2.0mm) 2-Lane PCIe Throughput of each lane PCIe Gen 2: 5 Gbps
Key Features	Standards Compliant PCI Express Base Specification r2.0 (Backwards compatible with PCIe r1.0a/1.1) PCI Power Management Spec r1.2 Microsoft Vista Compliant Supports Access Control Services Dynamic link-width control Dynamic SerDes Speed Control High Performance Non-blocking internal architecture Full line rate on all ports Cut-Thru latency: 140ns Maximum Payload Size - 2,048 bytes Read Pacing (intelligent bandwidth allocation) Dual Cast Dynamic Buffer Pool Architecture for faster credit updates PCI Express Power Management Link power management states: L0, L0s, L1, L2/L3 Ready, and L3 (with Vaux *not supported*) Device power management states: D0 and D3hot Active State Power Management (ASPM) Quality of Service (QoS) Two Virtual Channels (VC) per port Eight Traffic Classes per port Weighted Round-Robin Port & VC Arbitration
Lane Status LEDs Blink: Gen 1 speed Solid: Gen 2 speed	Upstream Lane Status LEDs UPCIe LED1: Upstream x1 Status LED UPCIe LED4: Upstream x4 Status LED UPCIe LED8: Upstream x8 Status LED Downstream Lane Status LEDs LEDPE1-1: Downstream Lane 11 Status LED LEDPE1-2: Downstream Lane 10 Status LED LEDPE2-1: Downstream Lane 9 Status LED LEDPE2-2: Downstream Lane 8 Status LED LEDPE3-1: Downstream Lane 14 Status LED LEDPE3-2: Downstream Lane 15 Status LED LEDPE4-1: Downstream Lane 12 Status LED LEDPE4-2: Downstream Lane 13 Status LED
Switch	SW1: PCIe Port Configuration 2,4: ON 1,3: OFF x8,x1,x1,x1,x1,x1,x1,x1,x1 (default) SW2_1~3: Select Upstream NT Port OFF/ON/ON : Port 1 (default) SW2_4: Non-Transparent Mode OFF: Disabled NT mode (default) ON: Enable
Computer Platform Requirements	Desktop computer equipped with a PCIe 2.0/3.0 x8, x16 slot

DU3X2-IPCIE2XG211

PCI Express (IOI Proprietary)	Two Dual-lane Internal PCIe Ports (IOI Proprietary) 10X2_19pin Header (Pitch=2.0mm) PCIe x2 Throughput of each lane PCIe Gen 2: 5 Gbps Compliant with PCI Express Base Specification Revision 2.0
USB Features	Compliant with USB 3.0 Specification Revision 1.0 Compliant with Extensible Host Controller Interface (xHCI) Specification revision 1.0 16 downstream USB ports support SS/HS/FS/LS data rates (5Gbps/480Mbps/12Mbps/1.5Mbps) Supports UASP (USB Attached SCSI Protocol) Supports xHCI debug capability Support for Ultra High-performance isochronous applications Support for Latency Tolerance Tolerance Messaging (USB)
USB Data Transfer Rate	Low-speed (1.5 Mbps) Full-speed (12.0 Mbps) High-speed (480.0 Mbps) Super-speed (5.0 Gbps)
Number of Ports	Sixteen USB 3.0 (Standard A-type Receptacle) cable ports (Provides USB 3.0 cable port lock mechanism) <
USB Bus Power Input (5V & 12V)	Either Big IDE 4-pin DC Power Connector or/and SATA 15pin Power Connector
Physical Dimensions	5.25" ODD Form Factor 146.6(W) x 42(H) x 109(D) mm NW: 380g

Applications

Octad Channel 32-port USB 3.0 Host Controllers

U3X8-PCIE8XE111
- IP8X-PCIE8XG201
- Two DU3X2-IPCIE2XG211
- Four CB-00592

Computer Platform

Note:
For the best performance (5.0 Gbps), It should be installed in a PCIe Gen 2 compliant slot in the host computer. Most computers have PCIe Gen 2 (5.0 Gbps) throughput on x8 or x16 slots.
A PCIe Gen 1 compliant slot reaches up to 2.5 Gbps throughput

Computer with PCI Express slot ( x8, x16)

Operating System Requirements

If OS is Windows 8 or later , there are inbox driver for Fresco USB 3.0 Host Controller.
Linux xHCI support under Linux kernel version 2.6.31 and after
USB 3.0 Host Drivers x86 (32-bit) and x64 (64-bit)
- Windows XP
- Windows Vista
- Windows 7
- Windows 8 and 8.1

Kit includes

U3X8-PCIE8XE111

IP8X-PCIE8XG201
Two DU3X2-IPCIE2XG211
Four CB-00592 --- Female 19pin to Female 19pin Cable, L=600mm