Products / Bridge Boards / IDE / to SATA

IDE-SATA07

Parallel ATA to Serial ATA Host Mode Converter featuring Marvell 88SA8052 Bridge Controller

Specifications

Downloads

Introduction

IDE-SATA07 is a Parallel ATA to Serial ATA Host mode Bridge Board featuring Marvell 88SA8052 Serial ATA bridge Controller.

IDE-SATA07 is ideally suited for tailgate interface applications for converting Serial ATA device into ATA device. Both ATA and ATAPI modes are supported using the same firmware.

Technical Specifications

Parallel ATA to Serial ATA Bridge Board:

Serial ATA:
- Compliant with Serial ATA 1.0
- 48-bit sector addressing
Serial ATA Connector:
- Signal + Power (7+15 pin) Female Type Connector
Parallel ATA:
- Ultra ATA/133 Parallel Interface
- 48-bit sector addressing
- Jumper for selecting Master and Slave
Parallel ATA Connector:
- Male IDC 2X20 pin Connector
Transfer Rate:
- Supports PIO and DMA modes
- Supports bus master DMA at 1.5Gbps burst rate
DC Power Connector:
- IDE Big 4-pin power connector
LEDs
- Power LED
- SATA PHY Ready LED
- Activity LED (Pin Header 2pin Pitch=2.54mm)

Application


For 5.25" ODD	For 3.5" HDD

Physical Dimensions

2.3 " x 1.00" (5.85cm x 2.54cm)
Direct Connect Vertical type

Kit includes

IDE-SATA07 Bridge Board